Flat Moulding- Casting the mould

Casting the MouldProducts:

•  Non-porous surface
• Sulfur Free clay
• Digital scales
• Measuring beakers
• Flat sticks
• Silicone Gel 25- A & B. DO NOT cross contaminate
• Wet wipes to wipe edges of containers
• Hot glue gun
• Fixer spray
• Mould release- 33Petrolease

Health and Safety

• Keep products well ventilated
• Wear gloves at all times

Remember: DO NOT mix with aloe vera- the silicone will not set. Be careful of hand creams and hand wash.

1. Create your sculpt in the clay on the plastic, bearing in mind the area in which you would like this to fit. Ensure edges are smoothed down well using sculpting tools.
2. If you think your mould may have dirt etc on it- wipe down with acetone
3. Place top half of a cut cup around the mould and seal all edges using hot glue gun
4. Mix equal parts Gel A and B- We used 75g A and 75g B. DO NOT CONTAMINATE.
5. Spray sculpt with fixer spray and let dry
6. Spray sculpt with mould release and let dry
7.  Pour silicone mixture onto mould and lay on a flat surface and leave to set.